Allroad Quattro V8-4.2L (BAS) (2004)
Fuel Gauge Sender: Service and Repair
All Wheel Drive
Sender For Fuel Gauge -G-, Removing And Installing
Removing
-
Removing fuel pump delivery module.
NOTE: If the fuel pump delivery module is only removed to remove the sender for fuel gauge -G-, the fuel return line and distributor connector do not
need to be disconnected. Place fuel pump delivery module beside tank opening.
-
Remove sender from accumulator by pressing down on releases -arrows-.
NOTE: For better illustration purpose the accumulator is shown without fuel tank.
Installing
Installation is the reverse of removal, however note the following:
-
Insert sender for fuel gauge into guide of outside of accumulator and press down until stop -arrow-.
-
Install fuel pump delivery module and observe Note and procedures regarding reconnecting battery.
Finishing steps:
-
Fill vehicle with fuel.
-
Checking entire resistance of sender for fuel gauge.
-
Specification: approximately 270 Ohm (Tank full)