Allroad Quattro V8-4.2L (BAS) (2004)
^
Place separator -l- between wheel bearing housing and wheel hub, and pretension.
Installation position: straight surfaces of blades point toward wheel hub.
^
Attach bell -2-, hollow piston cylinder -3- with tie bolt and special nut -4-.
^
Pull out wheel hub while holding device securely.
1. 17/2 Kukko separating tool
2. Bell E-40
3. Hollow piston cylinder H KZ-1 5
4. Special nut E-8-214 and be bolt
Pulling out wheel bearing
^
Attach pressure piece -1- with collar to bearing, pressure sleeve -2- with four stepped inside diameters to wheel bearing housing, hollow piston
cylinder -3- with tie bolt, and special nut -4-.
^
Pull out wheel bearing by actuating pump.
1. Pressure piece E-5
2. Pressure sleeve E-44-1
3. Hollow piston cylinder H KZ-15
4. Special nut E-8-214 and tie bolt
Pull bearing inner race off hub
^
Attach separator -1- behind bearing inner ring -2-.
Installation position: Beveled part of blades faces bearing inner ring.
^
Put on bell -3- and hollow piston cylinder -4- with tie bolt, screw on with special nut -5-, and pull off bearing inner ring.
1. 17/2 Kukko separating tool