Allroad Quattro V8-4.2L (BAS) (2004)
-
Remove screws -arrows- for the cover.
-
Carefully disengage 2-pin harness connector -arrow- and disconnect. (4-pin harness connector shown).
WARNING: When removing fuel level sensor 2 the fuel tank should only be 1/4 full. Otherwise large quantities of fuel escape.
-
Remove closing ring (driver side) using 3087 Fuel Tank Wrench.
-
Remove fuel level sensor 2 together with seal slightly out of opening in tank.
-
Disconnect harness connectors for sender for fuel gauge at inside (closing flange) of fuel level sensor 2.