Allroad Quattro V8-4.2L (BAS) (2004)
Throttle Position Sensor: Service and Repair
Accelerator Pedal W/Position Sensors, Removing and Installing
Accelerator Pedal (AP) With Position Sensors, Removing And Installing
Removing:
-
Remove storage compartment on drivers side.
-
Disconnect 6 pin connector -2-
-
Remove screws -1- and -3-
-
Remove the accelerator pedal (AP) module.
Installing:
Installation is the reverse of removal:
-
For vehicles with automatic transmission, the kick down function must be learned.
Tightening torque
Component
Nm
Accelerator pedal module at pedal mount
9 Nm (6 ft lb)