Allroad Quattro V8-4.2L (BAS) (2004)
-
Repair circuit malfunction using circuit diagram
If no problem is found, but the diagnosis pump still does not work during the Output check diagnosis:
-
Replace Leak detection pump (LDP) -V144-.
-
Observe the measures after reconnecting ECM.
Input circuit checking - Vehicles with electronic engine power control (drive-by wire)
-
Connect test box VAG1598/31 to the circuit harness connector; do not connect the ECM. Connect the ground clip of the test box to ground (not
shown in illustration).
WARNING: To avoid damaging electrical components, select the appropriate measurement settings on the measuring device before connecting to the
components.
-
Check the following circuit connections for open circuits and shorts to ground and/or battery positive:
Connector terminal
Test box VAG 1598/31 Socket
1
80
-
Repair circuit malfunction using circuit diagram
-
Observe the measures after reconnecting ECM