Allroad Quattro V8-4.2L (BAS) (2004)
-
Consider the installation position of the fuel sender for fuel supply:
-
Marking on fuel sender -2- must match marking on fuel tank -1-
-
Tighten closing ring with 120 Nm (89 ft lb).
-
Install fuel supply and return lines as previously marked.
-
Install cover for closing flange with indentation over connector.
NOTE: With Battery re-connected, remember to activate electrical equipment (radio, clock, window switches) according to operating instructions.
-
With ignition switched off, reconnect battery Ground (GND) strap.
-
After reconnecting battery, insert radio code.
-
Generate readiness code.
Finishing steps:
-
Fill vehicle with fuel.
-
Check entire resistance of fuel level sensor 2
-
Specification: approximately 270 Ohm (Tank full)
Tightening torque
Torque
Nm
Closing ring for fuel pump delivery module
145 Nm (106 ft lb)
Battery pole connections
5 Nm (44 in lb)