Allroad Quattro V8-4.2L (BAS) (2004)
Transmission Speed Sensor: Service and Repair
Sender For Transmission Output RPM -G195, Remove and Install
Sender for transmission output RPM -G195, removing and installing
Note: Do not re-use a sensor that was dropped (the permanent magnet breaks).
Removing
-
Remove connector from sensor.
-
Remove sender for transmission output RPM -G195 -C- at side of intermediate drive.
If gear oil drains when the sensor is replaced, the gear oil must be replaced or refilled after the repair.
Installing
Installation is in reverse order of removal.
Tightening torque