Allroad Quattro V8-4.2L (BAS) (2004)
Installing
NOTE: Always replace screw - 4 -.
-
Position side airbag module - 2 - such that locking pins - 3 - engage in holes - 7 -.
-
Push side airbag module up as far as it will go.
-
Tighten newly replaced screw - 4 - on side airbag unit to 10 Nm (7 ft lb).
-
Lay out airbag cable - 5 -.
-
Connect yellow connector of airbag wire and black connector of airbag Ground (GND) wire below the seat.
-
Re-install mounting trim.
-
Install seat.
-
Switch on ignition.
WARNING: Make sure that nobody is in the vehicle.
See Caution for connecting Telematics battery
-
Connect battery Ground (GND) strap.