Allroad Quattro V8-4.2L (BAS) (2004)
/Page-4597002.png)
-
Remove side panel.
-
Disengage tab on yellow connector - 3 - and disconnect connector.
-
Remove two bolts - 2 - at crash sensor.
-
Installing
-
Switch ignition on.
WARNING: No person may be inside the vehicle when connecting the battery.
See Caution for connecting Telematics battery.
-
Connect battery Ground (GND) strap.
2
-
Bolts (2x)
-
Tightening torque 9 Nm
3
-
Acceleration sensor connector
NOTE:
-
Observe safety precautions after connecting the battery.
-
If Airbag Malfunction Indicator Lamp (MIL) -K75- signals a malfunction after installation, DTC memory must be checked, erased and
once again checked using VAS 5051 tester.
