Allroad Quattro V8-4.2L (BAS) (2004)
/Page-3827001.png)
Front Steering Knuckle: Service and Repair
Wheel Bearing Housing (Steel), Removing and Installing
Wheel bearing housing (steel), removing and installing
Removing
^
Remove hubcap, for light-alloy wheels pull off center cap (use pulling hook in vehicle tools).
^
Unscrew hex bolt for drive axle.
^
Remove wheel.
^
Thread in all 5 wheel bolts again.
^
Pull cable of ABS wheel speed sensor out of bracket on brake caliper.
For brake disc HP - 2 - see procedure
^
Secure brake caliper to body using wire.
Note:
^
Do not allow brake caliper to hang on brake hose.
^
Remove brake disc.
^
Unscrew bolts -1- for backing plate.
^
Pull ABS wheel speed sensor out of wheel bearing housing.
^
Remove nuts -2- and -3-.
^
Remove rubber grommet -1- and disconnect harness connector -2-.
^
Remove cable for ABS wheel speed sensor from brackets (arrows).
