Allroad Quattro V8-4.2L (BAS) (2004)
/Page-3828003.png)
^
Press joint bolts of track control link off conical seating.
^
Remove nut -1- and hex bolt, and lift out both control arms -2-.
Slits in wheel bearing housing may not be widened with a chisel or similar tool!
^
Swing away wheel bearing housing toward side, in direction of (arrow), while pulling drive axle end out of wheel hub.
^
Unscrew nut from joint bolt of track control link.
^
Remove wheel bearing housing.
Installing
^
Insert wheel bearing housing.
^
Push outer joint of drive axle into wheel hub and hand-tighten new hex bolt.
Note: Remove any glue remaining on thread of joint bolt.
^
Insert joint bolt of track control link and guide link into wheel bearing housing.
^
Thread new self-locking nuts and tighten to 125 Nm.
Use 4 mm socket wrench to hold joint bolt if necessary.
^
Insert both joint bolts of top control arm into wheel bearing housing.
^
Tighten new self-locking nuts -1- to 40 Nm.
^
Press upper links down as far as possible when tightening!
^
Insert tie rod.
^
Install new self-locking nuts -4- and tighten to 50 Nm.
^
Tighten hex bolts -3- to a maximum of 5 Nm.
^
Install ABS wheel speed sensor
