Allroad Quattro V8-4.2L (BAS) (2004)
/Page-4013002.png)
^
Unscrew bolt-2- for control arm -1-.
^
Pull wheel bearing housing off drive axle.
Installing
Installation is the reverse of removal.
^
Bonded rubber bushings can only be turned to a limited extent. The bolted connections should therefore only be tightened when the vehicle is
standing on the ground.
Otherwise, the rubber bushing will be stressed and have a shortened service life.
^
Observe notes when installing drive axle
Tightening torques:
Drive axle to wheel hub
Use new bolt!
Tie rod to wheel bearing housing ................................................................................................................................................................................ 95 Nm
Control arm to wheel bearing housing ............................................................................................................................................................... 70 Nm + 90°
Wheel bearing housing to lower control arm .............................................................................................................................................................. 95 Nm
Coupling rod to wheel bearing housing ....................................................................................................................................................................... 55 Nm
Backing plate to control arm ....................................................................................................................................................................................... 10 Nm
Brake caliper to wheel bearing housing ...................................................................................................................................................................... 95 Nm
Shock absorber to control arm ........................................................................................................................................................................... 70 Nm + 90°
Always use new bolts.
After installation, position of steering wheel must be checked with a road test.
If steering wheel is crooked, an axle alignment must be performed!
