Allroad Quattro V8-4.2L (BAS) (2004)
^
Apply separator 3292, and tighten with spindle.
Blades of tool must be applied exactly between collar of bonded rubber bushing and wheel bearing housing.
^
Insert pin 3293/1.
^
Now, apply tool 3349 so that blades push exactly between bonded rubber bushing and wheel bearing housing.
^
Turn spindle -2- until bonded rubber bushing lifts slightly off of wheel bearing housing.
^
Now tighten bolt -1-.
^
Put on bridge 329M.
^
Turn hex bolt -1- to press out one of the two bonded rubber bushings.
Pressing out second bonded rubber bushing