Allroad Quattro V8-4.2L (BAS) (2004)
/Page-2718002.png)
^
Remove selector lever cable from selector lever.
From above:
^
Disengage lock cable from securing spring at mounting bracket by slightly lifting securing spring.
^
Remove 4 nuts.
From below:
^
Remove mounting bracket downward.
^
At the same time pull out selector lever cable from mounting bracket. Avoid kinking cable.
Installing
^
Install cable in reverse order of removal.
^
In addition, the following test steps must be performed and observed:
^
Move selector lever/selector shaft to "P" (parking lock must engage).
^
Lift vehicle.
^
Insert selector lever cable into mounting bracket.
Note: Do not kink selector lever cable.
^
Install mounting bracket to body.
^
Tighten 4 nuts from above with 10 Nm (7 ft. lbs.).
^
Attach rubber sleeve to cover of shift mechanism.
^
Connect electrical connector
^
Install lock cable and adjust
^
Install cover
^
Install handle for selector lever.
^
Attach selector lever cable to selector lever.
^
Install lock plate -A- for selector lever cable to mounting bracket.
Installation position:
Angled ends of lock plate must point toward end of selector lever cable.
^
Press ends of clamp -B- together and attach to end of selector lever cable.
^
Attach cover.
^
Tighten 4 nuts -arrows- to 10 Nm (7 ft. lbs.).
^
Check adjustment of selector lever cable and if necessary adjust.
^
Check ignition key lock.
^
Install drive shaft to transmission flange.
^
Install heat shield.
^
Attach front exhaust system to rear portion of exhaust system.
