Allroad Quattro V8-4.2L (BAS) (2004)
/Page-2770004.png)
^
Place valve body in position without force so that point of detent plate -1- engages in groove -2- of selector lever slide.
^
Then tighten valve body bolts (arrows) by hand.
Notes:
On transmissions with hydraulic control E1 7, a bolt (arrow -A-) is shorter or thinner than the other bolts. Observe allocation.
On transmissions with hydraulic control E1812, the bolt (arrow -A-) is not installed and can therefore be disregarded.
^
Then tighten valve body bolts to final tightening torque from the inside out
Only for transmissions with hydraulic control E18/2
^
Pull wire with connector -13- of sensor for transmission RPM -G182- between valve body and wiring harness upward.
^
Connect connector -B- to connector -A- at wiring harness.
^
Connect connector -C- to transmission Vehicle Speed Sensor (VSS) -G38-.
Only for transmissions with hydraulic control E17