Allroad Quattro V8-4.2L (BAS) (2004)
Constant Velocity Joint: Service and Repair
Triple Roller Joint AAR 3300 I, Assembling
Triple roller joint AAR 3300 i, assembling
Installation
^
Slide new CV boot onto shaft.
^
Press on securing ring -1- up to center of splines
^
Use special tools shown in illustration.
Instead of using T10065/2 special tool, T10065/3 special tool must be used depending on version.
Press triple roller star onto drive axle
Chamfer on star faces toward shaft, it facilitates assembly.
^
Place triple roller connections on shaft according to markings and drive on until impact.
This depiction is only valid for drive axles with a conical shape at the end (arrow).