Allroad Quattro V8-4.2L (BAS) (2004)
/Page-2811002.png)
Note:
^
When inserting, make sure that in each case the wide gap -a- at joint piece contacts narrow gap -b- at hub after swinging in.
^
Chamfer on inner diameter of be# hub (splines) must face large diameter of joint piece.
^
Swing in ball hub, to do so swing out hub far enough from cage (arrows) so that the balls have the distance of the running paths.
^
Swing in hub with balls by pressing forcefully onto cage -arrow-.
Check constant velocity joint for function:
Constant velocity joint is properly assembled, if the ball hub can be slid back and forth by hand over the whole compensation length.
Skid plate
The skid plate is installed on the Audi Allroad and may be installed on the Audi A6 with rough terrain suspension as of m.y. 2002.
