Allroad Quattro V8-4.2L (BAS) (2004)
/Page-2813002.png)
^
VAG1459 B/2 supplementary kit
^
Kukko 17/2 separator
^
Bell E-40
^
Pressure piece E-43
^
Pressure sleeve E-44-1
^
Pressure piece E-45
^
Loosen hex bolt for drive axle when vehicle is standing on its wheels (risk of accident).
^
Remove wheel and raise vehicle.
^
Pull cable of ABS wheel speed sensor out of bracket on brake caliper.
^
Pull ABS wheel speed sensor out of wheel bearing housing.
^
Remove adapter with brake caliper and hang on body with tie wire.
^
Remove brake disc and backing plate.
^
Remove nut -1- and hex bolt, and lift out both links -2-.
Slits in wheel bearing housing may not be widened with a chisel or similar tool!
^
Unscrew hex bolt for drive axle.
^
Swing out wheel bearing housing.
^
Take drive axle out of wheel bearing housing and be up.
Note: Place VAG13831A transmission lifter underneath (danger of accident if parts fall off when ejecting wheel hub and wheel bearing).
Pulling out wheel hub
^
Place separator -l- between wheel bearing housing and wheel hub, and pretension.
Installation position: straight surfaces of blades point toward wheel hub.
^
Attach bell -2-, hollow piston cylinder -3- with tie bolt and special nut -4-.
