Allroad Quattro V8-4.2L (BAS) (2004)
Transmission Speed Sensor: Service and Repair
Sensor For Transmission RPM - G182, Removing and Installing
Sensor for transmission RPM - G182, removing and installing
Note: Do not re-use a sensor that was dropped (the permanent magnet breaks).
Removing
-
Remove valve body.
-
Disconnect connector -A- on backside of valve body.
-
Remove sensor for transmission RPM - G182 -B- at valve body.
Installing
-
Install sensor for transmission RPM -1- using spacers -2- (length 8.7 mm).
-
Install connector on sensor.
-
Install valve body.
Note: The sensor side with the connector terminals points toward the valve body.
-
Replace ATF or refill after repair.