Allroad Quattro V8-4.2L (BAS) (2004)
/Page-3115003.png)
^
Carefully pull out knob -2- to dimension "a" out of selector lever handle -3-.
^
At the same time attach handle -3- with knob -2- in driving direction on selector lever to stop.
^
Turn handle -3- until knob -2- is pointing to driver. This causes handle to engage into grove of selector lever.
^
Attach handle -3- completely to selector lever. It must engage into circular grove of selector lever.
^
Push in knob -2- in handle of selector lever -3-.
^
Pull up sleeve -1- until it engages in handle -3-.
Fig. 8 Removing and Installing lock cable securing spring
Removing
^
To remove lock cable, lift securing spring upward -arrow B-.
^
Disengage spring -arrow A- at attachment hook -arrow C- and remove upward.
Installing
^
Insert spring from above -arrow B- and attach to attachment hook -arrow C-.
^
Adjust spring to fit evenly in groove -arrow A-.
^
To install lock cable, lift spring slightly arrow B-.
