Allroad Quattro V8-4.2L (BAS) (2004)
Rear Door Window Glass: Adjustments
Rear Door Window, Adjusting
To help check the adjustment, distance - a - (9 mm, or 0.354 in.) can be marked on the window along the B-pillar using a water-soluble pen.
-
Install door window onto window regulator.
-
Run door window upward until almost at top stop.
Door window - 1 - and seal - 4 - for door component carrier must be parallel with each another in the roof and C-pillar areas.
-
Press door window - 1 - toward B-pillar - 3 -.
NOTE: The edge of door window - 1 - must run 9 mm (0.354 in.) (distance - a -) inside seal - 4 - for door component carrier - 3 -.
-
Tighten bolts at window regulator mount.
Tightening torque: 2.5 Nm (22 in.lb)
-
Run window - 1 - up to top stop.
-
Check distance - a - and wipe off marking.