Cabriolet V6-2.8L (AFC) (1995)
Mirrors: Service and Repair
-
Loosen set screw (arrow) using 2 mm hex-wrench.
Tightening torque: 2 Nm (18 in. lb)
-
Remove inside rear-view mirror upward off from mounting plate.
Installing inside rear-view mirror mounting plate
CAUTION!
-
Read and observe all CAUTIONS! and WARNINGS! on adhesive compound labels.
-
Part numbers are listed here for reference only. Always check with your Parts department for the latest information.
Description of parts required
Part number
Glass-to-metal bonding kit
D 000 703
NOTES:
-
Adhesive is workable at room temperature and is completely hardened after several hours.
-
If reinstalling used mounting plate, first sand off old adhesive from bonding surface on mounting plate.
Dimension -a- for rear-view mirror: 130 mm (approx. 1-1/8 in.).
-
Clean bonding surfaces on inside of windshield and on mounting plate.
-
Spray on activator and wipe dry.
-
Spray cleaned bonding surface on windshield again with activator and allow to dry for 1 to 2 minutes.
-
Apply drop of metal adhesive to center of cleaned bonding surface of mounting plate.
-
Press mounting plate to prepared bonding surface for 30 seconds.
-
Attach rear-view mirror and secure with set screw.
-
Remove excess activator.