Cabriolet V6-2.8L (AFC) (1995)
Brake Pedal Assy: Service and Repair
NOTE: Manual transmission pedal assembly and procedure shown, automatic transmission similar.
Component Notes And Information
WARNING: Brake pedal travel must never be restricted by carpets or floor mats
NOTE: Grease contact points with white grease, Part No. G052 142 A2 or equivalent.
1
Return Spring
-
Fit U shaped end into pedal bracket
-
Connect other end in sleeve of clevis
2
Pedal Bracket
-
Do not remove to remove clutch and brake pedals
3
Return Hose
-
From brake fluid reservoir to clutch master cylinder
4
Locking Clip
-
Always replace
-
Install on pedal bracket shaft
5
Over Center Spring
-
Do not grease
-
Only grease contact points on pedal and/or pedal bracket
-
removing and installing, refer to Fig. 2, below
6
Locking Clip
-
Always replace
-
Install on pedal bracket shaft
7
Locking Clip
-
Always replace
-
Install on pedal bracket shaft
8
Pin
-
Install in clevis and clutch pedal
9
Clutch Pedal
-
Position set by adjustment of clevis
-
Attach to pedal bracket shaft
-
Can be removed and installed without removing bracket
-
Supplied as a replacement part with an injection moulded bushing (bushing is not replaceable)
10
Self Locking Nut
-
Always replace