Cabriolet V6-2.8L (AFC) (1995)
Wheel Speed Sensor: Service and Repair
Front
Component Notes And Information
1
Drive Axle With ABS Wheel Speed Sensor Rotor
-
Outer CV joint supplied with rotor as a replacement part
-
Before removing, pull out speed sensor slightly
-
After installing rotor, press wheel speed sensor back in up to it's shoulder using hand pressure only
2
ABS Wheel Speed Sensor
-
Same for right and left sides
-
To remove, pull out from wheel bearing housing
-
Ti install, press wheel speed sensor back in up to it's shoulder using hand pressure only
-
Disconnect sensor harness as follows
Left front connector, refer to Fig. 1, below.
Right front connector, refer to Fig. 2, below.
-
For wire harness routing, refer to Figs. 3 and 4, below.
3
Mounting Sleeve
-
Always replace
-
Same on right and left sides
-
Coat with brake cylinder paste before installing into wheel bearing housing.
-
Press into wheel bearing housing up to shoulder
4
Wheel Bearing Housing
-
Supplied as a replacement part with hole for mounting ABS wheel speed sensor mounting sleeve.
5
Hex Bolt And Washer/Collar Bolt
-
Always Replace
-
Tighten to: 200 Nm (148 ft lb) plus an additional 90°
WARNING:
^
Fastener -5- must only be loosened or tightened with the vehicle standing on the ground
^
Risk of accident.
Procedures:
Fig. 1 Left Front Wheel Speed Sensor Harness Connector
-
Disconnect coolent expansion tank and position aside
-
Remove harness connector from bracket and disconnect.