Cabriolet V6-2.8L (AFC) (1995)
Wheel Speed Sensor: Service and Repair
Rear
Component Notes And Information
1
Wheel Speed Sensor
-
Same for right and left sides
-
To remove, pull out of axle beam
-
Before installing, check wheel bearing play and adjust if necessary
-
To install, press in by hand up to shoulder
-
For wire routing, refer to Fig. 1, below
2
Mounting Sleeve
-
Always replace
-
Same for right and left sides
-
Coat with brake cylinder paste before installing
-
Press into axle beam up to shoulder
3
Axle Beam
-
Provided with bushings to hold wheel speed sensor
-
Coat mounting sleeve -2- with brake cylinder paste before installing
4
Stub Axle
-
For removal, refer to Suspension and Steering
5
ABS Wheel Speed Sensor Sensor Rotor
-
Drive off evenly with mandrel through threaded holes in hub
-
Press on to install, refer to Suspension and Steering
6
Wheel Hub
-
For removal and installation, refer to Suspension and Steering
Procedures
Fig. 1 Wiring Routing For Wheel Speed Sensor
-
Install wiring with rubber grommets into brackets provided on rear axle and floor pan
-
Connect wire and carefully install in floor pan with rubber grommet.
NOTE: The two harness connectors for the rear wheel speed sensors are located under the rear seat.