Cabriolet V6-2.8L (AFC) (1995)
Valve Guide Seal: Service and Repair
COMPONENT NOTES AND INFORMATION
Installing cylinder head cover, refer to Installation. See: Cylinder Head Assembly/Cylinder Head Cover/Service and Repair
1
Bolt
-
Tighten to: 20 Nm (15 ft. lbs.)
2
Intake manifold
3
Bolt
-
Tighten to: 10 Nm (7 ft. lbs.)
4
Cover
5
Bolt
-
Tighten to: 10 Nm (7 ft. lbs.)
6
Cylinder head bolt
-
Always replace
-
Tightening, refer to Procedures below.
7
Pressure Relief Valve
-
Replace if there are loud valve noises that affect the whole cylinder head
-
Replace if loosened in fitting
-
Secure with suitable thread locking compound
-
25 Nm (18 ft. lbs.)
8
Bolt
-
Tighten to: 10 Nm (7 ft. lbs.)
9
Camshaft Position (CMP) sensor housing
10
Cylinder head
-
Checking for distortion, refer to Procedure. See: Cylinder Head Assembly/Testing and Inspection
-
Resurfacing dimensions, refer to Resurfacing
11
Cylinder head gasket
-
Always replace
-
Identification: lettering on gasket must face upward
PROCEDURES
NOTE: Cylinder head installed
-
Remove toothed camshaft drive belt.
-
Remove camshafts and hydraulic lifters.
-
Remove spark plugs.