Cabriolet V6-2.8L (AFC) (1995)
Toothed Belt: Adjustments
ADJUSTING BELT TENSION
-
The toothed belt tension adjustment is done by turning the tensioning roller with 8 mm hex-key wrench.
-
Adjust tensioner so it can just be moved slightly by hand.
-
Check belt tension by gripping belt half-way between camshaft sprocket and coolant pump.
Twisting the belt with the thumb and index finger, it must be just possible to twist it approximately 90°.
-
Fully tighten tensioner center bolt with 8 mm hex-key wrench.
-
Tightening torque: 45 Nm (33 ft. lbs.)
-
Fully tighten camshaft sprocket bolts.
-
Tightening torque: 30 Nm (22 ft. lbs.) plus 1/2-turn (180°)
-
Remove crankshaft holding tool 3243.
-
Reinstall CKP sensor.
-
Tightening torque: 10 Nm (7 ft. lbs.)
NOTE:
-
If crankshaft center bolt has been removed:
^
Always replace.
^
Use only new double hex-head (12-pt) cap screw, grade 9.8.
^
Tightening torque (with bolt oiled): 200 Nm (148 ft. lbs.) plus additional 1/2 turn (180°)