Cabriolet V6-2.8L (AFC) (1995)
/Page-1417001.png)
Wheel Hub: Service and Repair
Rear
Rear
WARNING!
^
Do not re-use any fasteners that are worn or deformed in normal use.
^
Some fasteners are designed to be used only once, and are unreliable and may fail if used a second time.
^
This includes, but is not limited to, nuts, bolts, washers, circlips and cotter pins.
^
Always follow the recommendations in this information, replace these fasteners with new parts where indicated, and any other time it is
deemed necessary by inspection.
1. Axle beam
-
Welding or straightening are not permitted
2. Stub axle
-
For vehicles with ABS
-
Straightening is not permitted
3. Brake backing plate
4. Bolt with washer
-
Tighten to; 30 Nm (22 ft lb)
5. Stub axle
-
For vehicles without ABS
-
Straightening is not permitted
6. Seal
-
Fill area between sealing lips with multi-purpose grease
-
Drive in fully using soft-faced hammer
7. Inner wheel bearing
-
Drive out outer race with copper mandrel
-
Do not wash out when re-used
-
Driving in, refer to Fig. 5, below.
8. ABS wheel speed sensor rotor
-
Vehicles with ABS only
-
Drive off evenly working through threaded holes in hub
-
Pressing on, refer to Fig. 6, below.
9. Wheel hub
-
Fill with multi-purpose grease before installing
10. Outer wheel bearing
-
Drive out outer race with copper mandrel
-
Do not wash out when re-used
-
Driving in, refer to Fig. 4, below.
11. Thrust washer
