Cabriolet V6-2.8L (AFC) (1995)
/Page-2435002.png)
Make sure flange seal and 3-vaned plastic drive gear remain in place on drive motor housing.
NOTE: Keep the motor clean. Do not get dust and/or dirt on greased surfaces and parts. If additional grease is necessary use only grease Part No. G 000
450 02.
CAUTION!
Part numbers are listed here for reference only. Always check with your Parts department for the latest information.
-
Carefully remove 3-vaned plastic drive gear from drive shaft of new motor in direction of arrow.
Do not remove molded rubber plate from motor drive housing.
-
Check motor/drive parts (molded rubber plate, damping elements, etc.) for damage and replace if necessary.
-
Install 3-varied plastic drive gear into cable housing in direction of arrow.
CAUTION!
Make sure that the three damper elements fit properly into the recesses in the cable housing.
-
Install motor onto cable housing in direction shown (arrows).
