Coupe GT L5-2226cc 2.22L SOHC (KX) (1986)
Radiator Cooling Fan Motor: Technical Service Bulletins
Radiator Fan - Installing Snap Lock Wiring Connector
Applies To
ALL
Group
19
Subject
Radiator Fan
Part Identifier 1908
Key Points
Installing snap-lock wiring connector
A268
Number
86-01
December 19, 1986
Starting Jan. 1986, the electrical connection on replacement radiator cooling fan motors is now a snap-lock connector. When replacing a fan motor also
replace the connector on the wiring harness.
This snap-lock connector also was introduced as a running change during Jan. 1986 production.
Note
This work procedure will be applicable when all existing stocks of replacement radiator cooling fan motors with a push-on connector are exhausted.
Three wire harness
Parts required
Three pin connector
Part No. 191 906 232B
Qty 1
Rubber boot
Part No. 191 972 525B
Qty 1
Terminals
Part No. N 902 644 02
Qty 3
Work sequence
-
disconnect battery ground strap
-
cut off old connector from wiring harness
-
push wires through rubber boot
-
attach terminal to wire
-
insert wires into connector (cavity numbers on connector)
^
Red/Black to cavity 3
^
Red/White to cavity 2
^
Brown to cavity 1
-
attach connector to fan motor
-
attach rubber boot
-
reconnect battery ground strap
-
check fan for proper operation
Two wire harness
Parts required
Three pin connector
Part No. 191 906 232B
Qty 1