Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1354004.png)
Replacement/Front Suspension/Drive Axle Assembly Overview.
-
Slide the protective boot onto the joint.
-
Bleed protective joint boot.
-
Make sure the protective boot is seated on the joint correctly.
-
Protective joint boot must fit in groove and on joint contour.
-
Tension clamps on outer joint. Refer to => [ Large and Small Clamps, Clamping on Inner or Outer Joint ] See: Service and
Repair/Procedures/Large and Small Clamps, Clamping on Inner or Outer Joint.
