Q7 Quattro V6-3.6L (BHK) (2007)
Windshield Washer Spray Nozzle: Procedures
Spray Nozzles
Special tools, testers and auxiliary items required
‹› Windshield Washer Aiming Tool (T10127) equipped with needle (3125/5 A)
Adjusting
‹› The settings indicate the values for a moving vehicle, i.e. the spray from the jets is slightly offset when the vehicle is stationary.
-
Mark the six points on windshield using a water soluble marker:
-
Locate points from every single nozzle using Windshield Washer Aiming Tool (T10127).
-
If the spray area does not correspond to the specifications, the nozzle is contaminated and must be cleaned.
Cleaning the nozzle:
-
Remove nozzle. Refer to => [ Spray Nozzles, Removing and Installing ] See: Removal and Replacement.
-
Flush nozzle opposite to spray direction using clear water.
-
To remove remaining impurities, the nozzle must only be blown out opposite to spray direction using compressed air.
If the spray area still does not correspond to the specifications:
-
Replace nozzle.