Q7 Quattro V8-4.2L (BAR) (2008)
Front Subframe: Procedures
Subframe, Securing
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1331)
‹› Locating pins (T10300)
For certain assemblies on the vehicle, subframe or complete front axle must be removed. For installation, the original position of the subframe can be
retained by using (T10300). Always install locating pins just prior to lowering subframe or complete front axle.
‹› In order to insert locating fixtures, engine must be completely supported.
‹› Support 3.6L FSI engine completely with engine support bridge. Refer to => [ Affects vehicles with 3.6L
FSI engine ] See: Removal and Replacement/Subframe.
‹› Support 4.2L FSI engine completely with engine support bridge. Refer to => [ Affects vehicles with 4.2L
FSI engine ] See: Removal and Replacement/Subframe.
‹› Support 3.0L TDI engine completely with engine support bridge. Refer to => [ Affects vehicles with 3.0L
TDI engine ] See: Removal and Replacement/Subframe.
-
Remove bolts - 2 -.
-
At these two points, thread in (T10300) up to marking - B - by hand.