Q7 Quattro V8-4.2L (BAR) (2008)
‹› 25 Nm
5
Lock carrier
‹› Service position
-
Battery, disconnecting
-
Remove front bumper.
-
Loosen wheel housing in area of bolting point to bumper.
-
Remove screws on lower noise insulation.
-
Remove seal on lock carrier and transition to fender.
-
Remove headlamp.
-
Disconnect release at connector station.
-
On vehicles with charge air cooler, pressure hoses must also be disconnected
-
Remove screws - 4 - and - 3 -.
-
Remove upper right or left screws - 2 - from longitudinal member
-
Install Guide Pins (T10093) in threads that are now free.
-
Remove remaining screws - 2 -.
-
Remove lock carrier without stretching wires forward on guide pins.
CAUTION!
When removing lock carrier, wiring must not be pinched or kinked.
‹› Adjust headlamps after installing.