Q7 Quattro V8-4.2L (BAR) (2008)
Power Door Lock Switch: Service and Repair
Driver/Front Passenger Interior Locking Switch
-
Switch off ignition and remove ignition key.
-
Remove front door trim.
-
Disconnect electrical connectors - 1, 2, 3 -.
-
Remove screws - arrows - and remove inside door release mechanism from door trim.
-
Release retaining springs - arrows - and carefully press interior locking switch - 1 - out of inside door release mechanism.
Installing
Install in reverse order of removal, observing the following:
-
Press interior locking switch into switch mount until retaining springs engage.
-
Insert inside door release mechanism and tighten screws.
-
Install front door trim.
Tightening torque
Component
Nm
Inside door release mechanism to
door trim
2.5