Q7 Quattro V8-4.2L (BAR) (2008)
Wheel Bearing: Removal and Replacement
Wheel Hub and Wheel Bearing
Wheel Hub and Wheel Bearing
Special tools, testers and auxiliary items required
‹› Hydraulic cylinder (VAS 6178)
‹› Engine-/transmission jack (V.A.G 1383 A) with universal transmission support (V.A.G 1359/2)
‹› Separating tool (3 - Kukko 15/3)
‹› Assembly tool (T10205)
‹› Hollow piston cylinder (VAS 6179)
‹› Pliers for circlips, 180 mm internal circlip (VAS 5498)
‹› Pressure gauge w/connection (VAS 6179/1)
‹› During the entire work procedure, always ensure proper seating of tools and components (wheel bearing/wheel hub).
‹› Always place (V.A.G 1383 A) with (V.A.G 1359/2) beneath wheel bearing housing during entire procedure (danger of accident if parts fall off).
Pressing off
-
Remove the drive axle. Refer to => [ Drive Axle ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Rear Suspension/Drive Axle.
-
Remove brake caliper - 1 - and tie it with an wire - 2 - at brake line bracket - 3 -.
-
Remove brake disc.
-
Remove bolt - 3 - and rear speed sensor - 2 -.