audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Front Suspension|Page 2362 > < Front Suspension|Page 2360
Page 1
background image

Axle Nut: Service and Repair

Drive Axle Outer Joint Twelve Point Nut, Loosening and Tightening

Special tools, testers and auxiliary items required

‹› Torque Wrench (V.A.G 1601)

12-point outer drive axle joint nut, removing

-

Remove wheel covers, remove cover cap on light-alloy wheels (removal hook in vehicle tool kit).

CAUTION!
When loosening and tightening 12-point nut, vehicle must stand on wheels.

-risk of accident-

-

Loosen 12-point outer drive axle joint nut a maximum of 90° (only loosen with vehicle resting on wheels -accident risk-).

Affects vehicles with air suspension

-

Place vehicle on hoist. Refer to => [ Positioning Vehicle on Hoist and Wheels ] See: Steering and Suspension/Suspension/Service and
Repair/Procedures/Positioning Vehicle on Hoist and Wheels. 

Affect vehicles with coil springs

-

Raise vehicle and remove wheel.

Affects all vehicles

-

Tighten all five wheel bolts by hand.

A second mechanic is needed for the next step:

-

1. Mechanic: Sit in vehicle and operate foot brake

-

2. Mechanic: Remove 12-point drive axle nut.

If 12-point nut is loose or removed, wheel bearing should not be loaded. 

If the bearings are loaded by the vehicle's own weight the wheel bearing will be damaged. The wheel bearings will be stressed and the life expectancy
reduced.

If it should be necessary to move a vehicle whose drive axle has been removed, then before doing so install an outer joint in place of the drive axle and
tighten it to 150 Nm, or else wheel bearing will be damaged.

12-point outer drive axle joint nut, tightening

-

Replace 12-point nut

A 2nd technician is needed to tighten the 12-point drive axle nut: 

-

1. Mechanic: Sit in vehicle and operate foot brake.

-

2. Mechanic: Tighten the 12-point drive axle nut to 150 Nm.

-

Install wheel and place vehicle on wheels.

CAUTION!
When loosening and tightening 12-point nut, vehicle must stand on wheels.

-risk of accident-

-

Tighten 12-point nut to final torque (only tighten with vehicle resting on wheels -risk of accident-). Refer to => [ Coil Spring Suspension Strut,
Upper Control Arm, Mounting Bracket and Level Control System Sensor Assembly Overview ] See: Steering and

Front Suspension|Page 2362 > < Front Suspension|Page 2360