Q7 Quattro V8-4.2L (BAR) (2008)
Fuse Block: Service and Repair
Driver Side Vehicle Floor Main Fuse Carrier
Driver Side Vehicle Floor Main Fuse Carrier
Special tools, testers and auxiliary items required
‹› Pry lever (80 - 200)
Removing
‹› When installing, reinstall all cable ties that were loosened or cut during removal in the same locations.
-
Switch off ignition and remove ignition key.
-
Remove driver's seat.
-
Remove screw - 2 - and pull floor vent - 1 - up.
-
Release retaining clamps on back side of cover - 1 - in - direction of arrow A -.
-
Then remove cover in - direction of arrow B - from driver's seat console.
-
Pry cover - 1 - with Pry Lever (80 - 200) from floor covering.