Q7 Quattro V8-4.2L (BAR) (2008)
/Page-1455004.png)
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading
Diagnostic Trouble Codes
2. If necessary, erase the DTC memory. See: Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble
Codes/Clearing Diagnostic Trouble Codes
3. If the DTC memory was erased, generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes
