Q7 Quattro V8-4.2L (BAR) (2008)
Refrigerator Control Unit: Service and Repair
Cooler Compressor Control Module
Removing
-
Remove the cooler J698.
-
Disconnect the electrical connectors - 1 through 7 -.
-
Install the safety screw - 3 - all the way.
-
Remove the control module - 1 - from the bracket by moving it - arrow A -.
-
Remove the connector - 2 - from the compressor - arrows B -.
Installing
Installation is reverse of removal, noting the following:
-
Remove the safety screw until it is even with the outer side of the control module housing.
-
Install the cooler J698.