Q7 Quattro V8-4.2L (BAR) (2008)
-
Remove bolts - 4 - and - 5 -.
CAUTION!
Connectors on Seat Occupied Recognition Control Module (J706) - 6 - and Seat Occupied Recognition Pressure Sensor (G452) - 4 - must not
be disconnected.
-
Create photos or sketches of wire securing and routing.
-
Loosen seat wiring harness retainers and connectors so that this can be removed together with Seat Occupied Recognition Control Module (J706) -
6 - and Seat Occupied Recognition Pressure Sensor (G452) - 4 - without disconnecting or loosening connectors on Seat Occupied Recognition
Control Module (J706) and Seat Occupied Recognition Pressure Sensor (G452).
-
Fold seat cushion - 2 - upward.