Q7 Quattro V8-4.2L (BAR) (2008)
Acceleration Sensor: Service and Repair
Front Body Acceleration Sensors
Front Body Acceleration Sensors
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1783)
Removing
-
Place vehicle on hoist. Refer to => [ Positioning Vehicle on Hoist and Wheels ] See: Steering and Suspension/Suspension/Service and
Repair/Procedures/Positioning Vehicle on Hoist and Wheels.
-
Remove wheel.
-
Remove wheel housing liner.
-
Unplug connector - 1 -.
-
Remove bolt - 2 - and body acceleration sensor - 3 -.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
-
Install body acceleration sensor bolt - 2 - and tighten to 8 Nm.