Q7 Quattro V8-4.2L (BAR) (2008)
‹› If necessary, clean using dry rag, do not use cleaning agents.
6
Bolt
‹› Always replace after removal.
7
Tie Rod
‹› Conical pin must be free of grease and oil.
‹› If necessary, clean using dry rag, do not use cleaning agents.
8
Nut, 90 Nm
‹› Self-locking
‹› Always replace after removal.
9
Nut, 105 Nm
‹› Self-locking
‹› Always replace after removal.
10
Wheel Bearing
‹› Removal and installation, refer to => [ Wheel Hub and Wheel Bearing ] See: Wheel Hub and Wheel Bearing.
CAUTION!
‹› Avoid contaminating with dirt and damaging the seal when setting down/storing.
11
Securing Ring
‹› Check for proper seating.
12
Nut, 500 Nm
‹› Self-locking
‹› Always replace after removal.
‹› Before assembling, coat contact surface with assembly paste.
13
Wheel Hub
‹› Removal and installation, refer to => [ Wheel Hub and Wheel Bearing ] See: Wheel Hub and Wheel Bearing.
14
Bolt, 20 Nm
15
Cover Plate
16
Wheel Bearing Housing
‹› Removal and installation, refer to => [ Wheel Bearing Housing ] See: Wheel Bearing Housing.
‹› Conical bores must be free of grease and oil.
‹› If necessary, clean using dry rag, do not use cleaning agents.
17
Nut, 85 Nm
‹› Self-locking
‹› Always replace after removal.