Q7 Quattro V8-4.2L (BAR) (2008)
‹› Selector shaft lever must not be bent when pressing selector lever cable on, counterhold if necessary.
-
Carefully press selector lever cable - 2 - on selector shaft lever without bending lever.
Vehicles with 8-cylinder, 4.2L FSI engine:
-
Install heat shield over Multi-Function Transmission Range (TR) Switch (F125).
Vehicles with 6-cylinder, 3.0L TDI engine:
-
Install ATF lines. Refer to => [ ATF Lines and ATF Cooler ] See: Automatic Transmission/Transaxle/Transmission Cooler/Service and
Repair/Removal and Replacement/ATF Lines and ATF Cooler.
-
Automatic transmission fluid (ATF) level, checking and topping off. Refer to => [ ATF Level, Checking and Filling ] See: Automatic
Transmission/Transaxle/Fluid - A/T/Service and Repair/ATF Level, Checking and Filling.
All:
Further installation is in reverse order of removal.
-
Check adjustment of the selector lever cable. Refer to => [ Selector Lever Cable, Adjusting ] See: Automatic Transmission/Transaxle/Shift
Linkage/Shift Cable/Adjustments.