Q7 Quattro (4LB) V6-3.0L SC (CJWB) (2011)
Alignment: Specifications
Front Axle Specifications
*Wheel stop on outer wheel is reduced by this amount. It can also be indicated negatively in alignment computer, depending on manufacturer.
Rear Axle Specifications
Wheel Alignment is necessary when:
-
Vehicle shows handling problems.
-
Involved in an accident.
-
Axle components were removed.
-
Tire wear patterns are uneven.
NOTE:
-
Wheel alignment must only be performed using VW/ Audi-approved wheel alignment equipment!
-
Each time wheels are aligned, both front and rear wheels must be aligned.
-
Otherwise correct vehicle performance is not guaranteed and an off center steering wheel may exist.
-
Wheels should not be aligned until the vehicle has been driven 1,000 km - 2,000 km, since it takes this long for the suspension to settle.
-
The individual specifications should be followed as exactly as possible when making adjustments.
Test Requirements:
-
Tread depth difference may be no more than 2 mm on an axle.
-
Tires inflated to correct pressure.