R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Antitheft Motion Sensor: Service and Repair
Anti-Theft Alarm System Sensor
Removing
-
If the control module was replaced, select the Replace function for the respective control module in Guided Fault Finding or Guided Functions.
-
Remove front interior/reading light. Refer to => [ Front Interior Lamp/Reading Lamp ] See: Lighting and Horns/Courtesy Lamp/Service and
Repair/Roof Trim Lamps and Switches.
-
Release retaining clips - arrow A - and tip Anti-Theft Alarm System Sensor (G578) - item 3 - out of interior light/reading light - arrow B -.
-
Using a small screwdriver - 1 -, carefully unclip individual interior monitoring sensors - 2 - from interior light/reading light.
Installing
Install in reverse order of removal, observing the following:
-
Connect electrical connector.
-
Install front interior/reading light. Refer to => [ Front Interior Lamp/Reading Lamp ] See: Lighting and Horns/Courtesy Lamp/Service and
Repair/Roof Trim Lamps and Switches.