R8 Quattro Coupe V10-5.2L (BUJ) (2010)
9
(VAS 6350/4)
‹› Between the corners of the (VAS 6350/4) and the (VAS 6350/1) - dimension A - 1.20 m to 1.50 m.
Mount and Adjust the Calibration Device (VAS 6350/4).
-
Check which hole circle the rims have.
-
Install the correct wheel pick-ups.
-
Use the (VAS 6350/5).
-
To do so, secure three (VAS 6350/1)in the hole circle to each wheel pick-up.
-
Attach paddles to both (VAS 6350/1) and secure them with clamping screw.
-
Place (VAS 6350/1) on wheel bolts on rear wheels.
The (VAS 6350/1) are positioned by the O-rings in the adapters and held in place.
‹› Mount the (VAS 6350/1) on the wheel so that if the wheel has anti-theft wheel bolts, they do not contact the (VAS 6350/1).
-
Set the paddles via the clamping screw so that they are free to move just above the ground.
Make sure the paddles move easily.
-
Position the (VAS 6350/4) behind the vehicle at a distance of 1.47 m to 1.90 m to the rear wheels, see - dimension A - in the illustration.
-
Bring (VAS 6350/4) to a horizontal position.
-
To do so, twist plastic feet under (VAS 6350/4) so that air bubble in level is located exactly in the center of the indicator - arrow -.