R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Parking Assist Control Module: Service and Repair
Parking Aid Control Module
Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] See: Lighting and Horns/Service Precautions.
Removing
-
If the control module was replaced, select the Replace function for the respective control module in Guided Fault Finding or Guided Functions.
-
Switch off ignition and remove ignition key.
-
Remove the driver seat.
-
Lift the carpet under the driver seat.
-
Remove the nuts - 1 and 3 - and the parking aid control module (J446) - item 2 -.
-
Disconnect electrical connectors - 4, 5, 6 -.
Installing
‹› Tightening specification => [ tightening specifications ] See: Collision Avoidance and Parking Assist Systems/Service and Repair.
Install in reverse order of removal, observing the following:
-
Install the carpet.
-
Install the driver seat.