R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Pull the front bumper cover - 3 - forward slightly.
-
Place a container under the right side of the vehicle and disconnect the headlamp washer system hose connection - 2 - by pressing the release
button - 1 -.
Installing
‹› Gap dimensions => [ Front Bumper Cover Gap Dimensions ] .
‹› Tightening specifications => [ Bumper Cover Assembly Overview ] See: Bumper Cover Assembly Overview.
Installation is reverse of removal, but note the following:
-
Install the headlamp and wheel housing liner trim => [ Headlamp and Wheel Housing Liner Trim ] See: Fender/Front Fender/Front Fender
Liner/Service and Repair/Headlamp and Wheel Housing Liner Trim.