R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Remove the bolts - arrows - by counterholding the nuts.
-
Remove the impact member - 2 -.
Installing
‹› Tightening specifications => [ Impact Member Assembly Overview ] See: Impact Member Assembly Overview.
Installation is reverse of removal, but note the following:
-
Install the rear bumper cover => [ Rear Bumper Cover ] See: Rear Bumper/Rear Bumper Cover / Fascia/Service and Repair/Rear Bumper Cover.
-
Install the bumper cover center section => [ Bumper Cover Center Section ] See: Front Bumper Cover / Fascia/Service and Repair/Bumper Cover
Center Section.